reviseren Fox Float uit Enduro
Moderator:Beheerders
kan dat in Nederland? en zo ja waar? en zo nee waar dan wel?
(voor mij gebruikelijk om een demper om de 2 jaar te reviseren)
(voor mij gebruikelijk om een demper om de 2 jaar te reviseren)
Re:reviseren Fox Float uit Enduro
www.sabma.com
Je kan alles rechtstreeks opsturen naar Mario van Sabma(kost 100€ voor gewone revisie)
Grtz
Martijnie
Je kan alles rechtstreeks opsturen naar Mario van Sabma(kost 100€ voor gewone revisie)
Grtz
Martijnie
Re:reviseren Fox Float uit Enduro
gewoon zelf doen, wat van dat speciale vet en sealkit aanschaffen, op de fox-site naar het filmpje kijken en klaar is kees
Re:reviseren Fox Float uit Enduro
Inderdaad stelt helemaal niks voor, wel proberen om het sealkitje in de US te bestellen, scheelt ongeveer 900% met de Europese prijs.
Het hydraulische circuit zou ik alleen niet zelf aan beginnen.
Het hydraulische circuit zou ik alleen niet zelf aan beginnen.
Re:reviseren Fox Float uit Enduro
Is ook niet reviseren van servicen...
Re:reviseren Fox Float uit Enduro
op de fox site zie ik online movies, daar klik ik op maar dan zie ik geen films staan. jullie wel?
Re:reviseren Fox Float uit Enduro
:-* :-* :-*
ik zocht dus niet op de goede plek. nu een site in de sates waar ze die sealkit verkopen.
ik zocht dus niet op de goede plek. nu een site in de sates waar ze die sealkit verkopen.
Re:reviseren Fox Float uit Enduro
Jurriaan schreef:
:-* :-* :-*
ik zocht dus niet op de goede plek. nu een site in de sates waar ze die sealkit verkopen.
Mailtje naar de servicedesk van Fox (De kerel met wie ik contact heb gehad heet Joy Avilla, mailadres weet ik niet uit mijn hoofd maar heb ik al wel eens gepost in een andere thread) Eerst sturen ze je naar de europese dealers. Moet je niet doen want dat is dus duur. (35E ipv $3,5 !!)
Je moet dus zeggen dat je rechtstreeks bij hen wil kopen. Betalen met creditcard (gaat goed, heb ik al 2x gedaan) Het enige wat ik niet zeker weet is of ze ook naar het buitenland verzenden. Ik heb het tot nu toe weten te combineren met kennissen die in de VS op vakantie waren.
Re:reviseren Fox Float uit Enduro
op het filmpje oogt het simpel. dat wil ik wel een keer doen.
Fox mailen dus. wat voor die olie nodig is zie ik niet helemaal. dat kan toch ook met niet fox olie?
Fox mailen dus. wat voor die olie nodig is zie ik niet helemaal. dat kan toch ook met niet fox olie?
Re:reviseren Fox Float uit Enduro
Hij zegt ook wat je als alternatief kunt gebruiken...
Re:reviseren Fox Float uit Enduro
Daar hoef je echt geen Fox fluid voor te kopen hoor. Ik gebruikte tot voor kort gewone Judy butter. Werkt perfect. Nu heb ik daar Ultra Slick voor.
Re:reviseren Fox Float uit Enduro
manitou butter ;D
Laat ik nou een 2002 demper hebben.
FOX Racing Shox has announced that the company has discovered a batch of 2002 Float rear shocks that are subject to slow air loss. FOX acknowledges that it received a shipment of air-sleeve seals made from an incorrect rubber compound and that these seals were used in a low percentage of 2002 Float shocks.
The questionable seal will hold air pressure while the bike is not being ridden but has the potential to slowly leak air while ridden. If you are experiencing this air-loss symptom, you should contact FOX for a free upgraded seal kit.
The kit will come with complete instructions on how to perform this 10-minute service. No special tools are required, according to FOX. In fact, the steps required to replace this seal are the same as the Air Sleeve Service listed under the General Maintenance section of the FOX Rear Shock OwnerÂ’s Manual and as a downloadable service video on the FOX website, www.foxracingshox.com
FOX feels very confident that this upgrade can be easily performed at the consumer or dealer level. However, if a consumer does not feel comfortable performing this service, they may send their shock to an Authorized FOX Service Center to receive this product upgrade free of charge.
Only a limited number of 2002 Float rear shocks are affected by this issue and only 2002 products are eligible for this free upgrade. You should contact FOX or its local importer if you are unsure of the model year of your shock. In the USA the number is 1-800-FOX-SHOX.
Laat ik nou een 2002 demper hebben.
FOX Racing Shox has announced that the company has discovered a batch of 2002 Float rear shocks that are subject to slow air loss. FOX acknowledges that it received a shipment of air-sleeve seals made from an incorrect rubber compound and that these seals were used in a low percentage of 2002 Float shocks.
The questionable seal will hold air pressure while the bike is not being ridden but has the potential to slowly leak air while ridden. If you are experiencing this air-loss symptom, you should contact FOX for a free upgraded seal kit.
The kit will come with complete instructions on how to perform this 10-minute service. No special tools are required, according to FOX. In fact, the steps required to replace this seal are the same as the Air Sleeve Service listed under the General Maintenance section of the FOX Rear Shock OwnerÂ’s Manual and as a downloadable service video on the FOX website, www.foxracingshox.com
FOX feels very confident that this upgrade can be easily performed at the consumer or dealer level. However, if a consumer does not feel comfortable performing this service, they may send their shock to an Authorized FOX Service Center to receive this product upgrade free of charge.
Only a limited number of 2002 Float rear shocks are affected by this issue and only 2002 products are eligible for this free upgrade. You should contact FOX or its local importer if you are unsure of the model year of your shock. In the USA the number is 1-800-FOX-SHOX.